Please take care in selecting the options you require. These wash troughs are configured to order and we regret that no order cancellations can be accepted once configuration to customer specifications has commenced.

Front Support Legs: The wash trough is designed to be wall-hung but more than half of buyers choose to add front support legs, to give extra strength. This is particularly worthwhile for wash troughs longer than 1800mm. If there is concern that the wash trough could be sat upon or leaned on heavily, and the front will not be supported by a panel, then legs are recommended.

Thermostatic Mixing Valve (TMV3): For premixing hot and cold water to a consistent comfortable temperature, a TMV3 valve is required.  It is also recommended for wash troughs with both cold and hot taps, to help prevent scalding. As an option, a 2-in-1 TMV3 from Dart Valley Systems can be supplied. Click here for details.

Number of Tap Stations (users):  This allows us to calculate the appropriate locations where tap holes are to be drilled, if they are required.

Tap Hole Type: There is a choice of tap hole configurations to fit standard tap singles and pairs plus monobloc mixer taps. If "Tap holes to match taps chosen below" is selected, then holes will be drilled to meet the standard configuration for the quantity and type of taps selected in the Include taps option.
Click here if you would like to read more detail on standard tap hole configurations.

If you require a tap hole configuration not shown as an option, please select "Special requirement". Then provide a specification in the Tap Holes - Special Requirement text box. Alternatively, please call us on 0845 202 4535 to discuss.

Include taps with appropriate tap holes: Click here to view more details on the taps offered. There are options to include a popular tap style with your order, configured appropriately for the length of wash trough and number of users. All of the taps are robust and designed for heavy use. Tap holes will be drilled to match the standard configuration for the chosen tap style and quantity, unless a Tap Holes - Special Requirement has been specified.

Deck mounted soap dispensers: A high quality dispenser, with stainless steel head, designed for mounting on the tap deck is available. Typically 1 dispenser is shared by the users of the two adjacent tap stations. If selected, appropriate holes to accept the soap dispensers will be drilled in the tap deck.

Stainless steel soap dispensers: Click here for details on the soap dispenser model offered at a discount with wash troughs.

Stainless steel paper towel dispensers: Click here for details on the towel dispenser model offered at a discount with wash troughs.

Installation
To install the wash trough, offer the unit to the wall at the desired height and, after ensuring that the unit is level, carefully mark the position of the screw holes in the rear upstand and the screw holes in the integral wall brackets (underneath). Remove the trough, drill and plug the holes and secure the trough firmly to the wall using suitable (non corroding) fasteners.

If optional front support legs have been supplied, these should be attached to the fixing studs provided before offering the wash trough to the wall. The leg(s) should be vertical and the foot in each support leg should be adjusted to the floor before, drilling, plugging and screwing into position. Fit any taps as required into the tap holes provided. Fit the waste to the trough, and make all plumbing connections

Earthing Continuity
All basins are provided with a number of fixing points on to which an earthing continuity wire with an end terminal can be secured.

Maintenance
Routine cleaning is necessary to maintain the appearance of stainless steel. Washing with soap or a mild detergent and warm water, applied with a sponge or bristle brush, followed by a clear water rinse is all that is required.