Flush Controller Option

Flush Controller Option


Marnic Water Watch PIR Sensor Flush Contoller  - £99 when purchased with a urinal

This is a wide-angle PIR sensor manufactured by Marnic Technologies, in an enamel painted steel case. Usually set to flush 20mins after the urinal has been used and only after 12 hours if not used.
 
Includes:
- Flush controller box with sensor eye for wall or ceiling mount above the urinals
- Norgren (Webber) Solenoid valve for fitting to water supply (15mm compression fit)
- 4.5 volt battery (typically lasts 2 to 4 years)
- Approx 1m of 2 core cable to connect controller to solenoid
 
Features:
- Up to 90% savings on water costs
- Extremely reliable and low maintenance
- Vandal resistant case made from heavy gauge steel
- 4.5v alkaline Duracell battery with tail
- Battery low indicator as standard, gives approximately 3 months advance warning
- Low power consumption - typical battery life 2-4 years depending on frequency of flush
- Wide angled passive infra-red sensor, occupancy detection
- Simple calibration for correct cistern fill times and flush frequencies
- Valve open switch to input time it takes to fill cistern
- Maximum flush frequency is up to 4 per hour
- Janitorial flush can be set for 12 hours or 24 hours of non-use
 
 
 
 
 
Water Watch Instruction Manual           Water Watch Instruction Manual - Gentworks Edition (185k)
 
 
Further details can be found at www.waterwatch.co.uk